Close

Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Articles Articles
Filter by: Last 7 Days Clear All
  • Redzwulf's Avatar
    1 Day Ago
    General rule is next size up. Tip tops are measured in 1/64" increments. In your case, it is recommended to use a 5.5 tip top which is 5.5/64"...
    3 replies | 130 view(s)
  • pencoat's Avatar
    4 Days Ago
    Thx Eric. Just wondering why the tiptop size recommendation is 5.5 and the spec for that blank id 5.0? Is it a general rule of thumb to go 1/2 point...
    3 replies | 130 view(s)
  • Redzwulf's Avatar
    6 Days Ago
    Try this. Remember these blueprints are to get you close and we always advise you to do static testing. Regards, Eric
    3 replies | 130 view(s)
No More Results